Clip Connector Instructions

Underglow connectors are used to help you customize your Underglow display by using Cross, T and 90° connectors.

Be sure to align strips with markings on connectors.

1. Once you have finalized your Underglow layout. Identify the LED strips that need to be cut and  clipped together. Be sure to unplug Underglow from its power supply before cutting.

NOTICE!: The Underglow LED Strips can only be cut long the leads. (Designated here with a scissor clipping mark)

2.  Cut along the metal leads, separating the LED strip.

3. Gently separate the protective clear coating, from the white circuit ribbon, be careful to not expose LED Light. Do not clip excess clear coating at this point.

4. Unsnap the plastic latches on the connectors, exposing the metal leads inside.

• • Take the LED strips you have prepared, and slide the strip underneath the metal leads, and plastic lip on the connector.
  • Clamp the connector lid once the LED strip is in place. The teeth on the lid will secure the LED strip. Be sure that both strips are aligned properly before securing connector.

5. Once both LED strips and connector are secure, cut and remove the excess protective clear coating, so that it is flush with the connector piece.

6. Upon completion, reconnect the power supply to test the new connection. If an LED strip is unresponsive, insure that all metal leads are touching, and aligned correctly.